Frequently Asked Questions
Upgrade ODS Control 10 to the new E-Port Controller
The new E-Series Controller
A new E-Series replacement battery controller costs $125 each
Inc. GST Postage Handling.
This product will be sent Australia Post after payment has been received.
When payment has been confirmed your order will be processed
To fully charge the battery allow about 8 hours.
Upgrade from the old L10 controller to the E-Port controller
You could just change your battery again if your old L10 controller is in good condition; this is the cheapest and best option,
this will work for 70 percent of the old controller, but if this does not
work then your old controller is damaged, and you will not be able to
return the battery kit once you have tried to charge it.
A new L 10 battery replacement kit costs $65.00 each Inc. GST and Postage and Handling.
You could upgrade to the new E-Port controller and wall plate by OZRoll.
You will need an E-Port controller, costs $125 each.
1 Replacement wall plate $8.50, this wall plate is smaller than your existing L10 wall plate, and it will not cover both of the existing screw holes that held your old L10 wall plate.
1 E-Port Wall plate Conversion Kit $16.50. This conversion kit uses the existing fixing points that secured the old L10 wall plate.
Your old L10 charger will charge the new E-Port controller if it's in good condition.
This is a simple job, unscrew the old wall plate, pull of the 2 bullet clips that are fixed to the 2 wires, and push the 2 clips onto the new wall plate, and screw the new wall plate back to the wall.
A new battery Charger costs $12.50.
Postage Handling for the Charger is $15.00 when sold separately.
Replacement wall plate $8.50.
Postage and Handling for the Wall Plate is $15.00 when sold separately.
Replacement wall plate conversion kit $16.50.
Postage and Handling for the Wall Plate conversion kit is $15.00 when sold separately.
Please contact us if your postage charges are more than $30.00, we may be able to help.
It should be noted that the controller can only be recharge when it is removed from the wall plate, and plugged DIRECTLY into the controller, then the CHARGE LED will illuminate. It will not charge in the wall plate unless it is connected to the solar panel.